TP-Link T3700G-28TQ User Manual page 309

WRR-Mode: Weight Round Robin Mode. In this mode, packets in all the queues are sent in
2.
order based on the weight value for each queue and every queue can be assured of a
certain service time. The weight value indicates the occupied proportion of the resource.
WRR queue overcomes the disadvantage of SP queue that the packets in the queues with
lower priority cannot get service for a long time. In WRR mode, though the queues are
scheduled in order, the service time for each queue is not fixed, that is to say, if a queue is
empty, the next queue will be scheduled. In this way, the bandwidth resources are made full
use of. The default weight value ratio of TC0, TC1, TC2, TC3, TC4, TC5 and TC6 is
1:2:3:4:5:6:7.
SP+WRR-Mode: Strict-Priority + Weight Round Robin Mode. In this mode, this switch
3.
provides two scheduling groups, SP group and WRR group. Queues in SP group and WRR
group are scheduled strictly based on strict-priority mode while the queues inside WRR
group follow the WRR mode. In SP+WRR mode, TC6 is in the SP group; TC0, TC1, TC2 to
TC5 belong to the WRR group and the weight value ratio of TC0, TC1, TC2 to TC6 is
1:2:3:4:5:6:7. In this way, when scheduling queues, the switch allows TC6 to occupy the
whole bandwidth following the SP mode and the TC0, TC1, TC2 to TC5 in the WRR group
will take up the bandwidth according to their ratio 1:2:3:4:5:6.
The QoS module is mainly for traffic control and priority configuration, including five submenus:
Class of Service, DiffServ, Bandwidth Control, Voice VLAN and Auto VoIP.
Figure 12-4 SP-Mode
Figure 12-5 WRR-Mode
298