Member Port
UNIT:
Member Port:
Tips:
Load-balancing algorithm is effective only for outgoing traffic. If the data stream is not well
1.
shared by each link, you can change the algorithm of the outgoing interface.
Please properly choose the load-balancing algorithm to avoid data stream transferring
2.
only on one physical link. For example, if the destination device of the packets is a server
with the fixed MAC address and IP address, you can set the algorithm as "SRC MAC+SRC
IP" to allow the switch to determine the forwarding port based on the source MAC
addresses and source IP addresses of the received packets.
6.2.3 LACP Config
On this page, you can configure the LACP feature of the switch.
Choose the menu Switching→LAG→LACP Config to load the following page.
Select the unit ID of the desired member in the stack.
Select the port as the LAG member. Clearing all the ports
of the LAG will delete this LAG.
Figure 6-10 LACP Config
66