TP-Link T3700G-28TQ User Manual page 159

Layer 2 network. MLD Snooping Querier can act as an MLD Router in Layer 2 network. It can
help to create and maintain multicast forwarding table on the switch with the Query messages
it generates.
Choose the menu Multicast→MLD Snooping→Querier Config to load the following page.
The following entries are displayed on this screen:
MLD Snooping Querier Config

Querier Mode:
Query VLAN
Address:
MLD Version:
Query Interval:
Expiry Interval:
MLD Snooping Querier Table

Select:
VLAN ID:
Query Mode:
Election Participate:
Figure 9-13 Packet Statistics
Enter the Query mode which for the MLD snooping querier on
the device. When enabled, the MLD snooping querier sends out
periodic MLD queries that trigger MLD report messages from
the switches that want to receive IP multicast traffic. The MLD
snooping feature listens to these MLD reports to establish
appropriate forwarding.
Enter the General Query Message source IP address.
Enter the MLD version used in periodic MLD queries.
Enter the time interval of sending a general query frame by MLD
Snooping Querier.
Enter the Expiry Interval which is amount of time the device
remains in non-querier mode after it has discovered that there is
a multicast querier in the network.
Select the desired entry. It is multi-optional.
Displays the ID of the VLAN that enables MLD Snooping Querier.
Displays the Querier Mode of VLAN.
Displays the Election Participate of VLAN.
148