TP-Link T3700G-28TQ User Manual page 35

The following entries are displayed on this screen:
IPv6 Configuration

IPv6:
IPv6 Protocol:
DHCPv6 Client DUID:
AutoConfig:
Add a IPv6 Address

Address Format:
Figure 4-9 Management Port IPv6
Enable or disable IPv6 function globally on the management
port.
Specify IPv6 network information allocate mode of the
management port.
None: Setup manually.

DHCP: Allocated through DHCP.

The client identifier used by the DHCPv6 client (if enabled)
when sending messages to the DHCPv6 server.
Choose whether to allow to enable the IPv6 stateless
address autoconfiguration mode via the RA message on the
management port.
You can select the IPv6 address format according to your
requirements.
EUI-64: Indicates that you only need to specify an

address prefix, and then the system will create a IPv6
address automatically.
Not EUI-64: Indicates that you have to specify an intact

IPv6 address.
24