Dhcp Server - TP-Link T3700G-28TQ User Manual
Hide thumbs
Also See for T3700G-28TQ:
- Cli reference manual (424 pages) ,
- User manual (415 pages) ,
- Reference manual (408 pages)
Table of Contents
Advertisement
Steps Operation
2
Add interface
VLAN 20
3
Add static route
entry
Configure Switch B
Steps Operation
1
Add interface
VLAN 20
2
Add interface
VLAN 30
3
Add static route
entry
Configure the PCs
Configure the default gateway of PC1 as 192.168.0.1 and the default gateway of PC2 as
192.168.2.1.
10.4 DHCP Server
DHCP module is used to configure the DHCP functions of the switch, including two submenus,
DHCP Server and DHCP Relay.
Overview
DHCP (Dynamic Host Configuration Protocol) is a network configuration protocol for hosts on
TCP/IP networks, and it provides a framework for distributing configuration information to
hosts. DHCP is adding the capability of automatic allocation of reusable network addresses
and additional configuration options. DHCP captures the behavior of DHCP participants so the
administrator can manage the parameters of the host in the network.
As workstations and personal computers proliferate on the Internet, the administrative
complexity of maintaining a network is increased by an order of magnitude. The assignment of
Note
Required. On page Routing→Interface→Interface Config, add
interface VLAN 20 with the mode as static, the IP address as
192.168.1.1, the mask as 255.255.255.0 and the interface name
as VLAN20.
Required. On page Routing→Static Routing→Static Routing
Config, add a static route entry with the destination as
192.168.2.0, the subnet mask as 255.255.255.0 and the next hop
as 192.168.1.2.
Note
Required. On page Routing→Interface→Interface Config, add
interface VLAN 20 with the mode as static, the IP address as
192.168.1.2, the mask as 255.255.255.0 and the interface name
as VLAN20.
Required. On page Routing→Interface→Interface Config, add
interface VLAN 30 with the mode as static, the IP address as
192.168.2.1, the mask as 255.255.255.0 and the interface name
as VLAN30.
Required. On page Routing→Static Routing→Static Routing
Config, add a static route entry with the destination as
192.168.0.0, the subnet mask as 255.255.255.0 and the next hop
as 192.168.1.1.
170
Advertisement
Table of Contents
