Protected Ports - TP-Link T3700G-28TQ User Manual

Entry Description:
Max Learned MAC:
Learned Num:
Learn Mode:
Status:
Note:
Port Security cannot be enabled on the member port of a LAG, and the port with Port
1.
Security enabled cannot be added to a LAG.
On one port, Port Security and 802.1X cannot be enabled at the same time.ort Security
2.
function is disabled when the 802.1X function is enabled.

6.1.4 Protected Ports

This feature is used to restrict the communication between the specific ports. A port that is a
member of a protected ports group is a protected port. Protected ports in the same protected
ports group cannot forward traffic to each other, even if they are in the same VLAN. But the
protected ports can forward traffic to the unprotected ports and the ports that are in a different
group.
Choose the menu Switching→Port→Port Isolation to load the following page.
The above page displays the information of protected ports groups. Click Edit to configure the
group on the following page.
Specify the maximum number of MAC addresses that can be
learned on the port. When the learned MAC address number
reaches the limit, the port will stop learning.
Displays the number of MAC addresses that have been
learned on the port.
Select the Learn Mode for the port.
Dynamic: The switch will delete the MAC addresses that
•
are not used or updated within the aging time. It is the
default setting.
Static: The learned MAC addresses are out of the
•
influence of the aging time and can only be deleted
manually. The learned entries will be cleared after the
switch is rebooted.
Enable or disable the port security feature on the port. By
default, it is disabled.
Figure 6-5 Port Isolation Config
58