Application Example For Static Mroute - TP-Link T3700G-28TQ User Manual

The following entries are displayed on this screen:
Static Mroute Config

Source:
Source Mask:
RPF Neighbor:
Distance:
Static Mroute Config Table

Select：
Source:
Source Mask:
RPF Neighbor:
Distance:
Click delete to delete the selected entry.

11.5.2 Application Example for Static Mroute

Network Requirements

1. The network runs PIM DM and all the switches in the network support multicast features.
2. Switch A, Switch B and Switch C run OSPF protocol.
3. In normal circumstances, Receiver receives multicast data from Source through the path
Switch A-Switch B, which is the same as the unicast route.
4. After the configuration takes effect, Receiver will receive multicast data from Source
through the path Switch A-Switch C-Switch B.
Enter the IP address that identifies the multicast source of
the entry you are creating.
Enter the subnet mask to be applied to the Source.
Enter the IP address of the neighbor router on the path to
the mroute source.
Enter the Administrative distance of static mroute. The
range is 0-255 and default is 0. The lower the distance, the
better the preference.
Select the static mroute entry to modify.
Displays the IP address of the multicast source.
Displays the subnet mask of source.
Displays the IP address of the neighbor router.
Displays the Administrative distance of static mroute.
293