TP-Link T3700G-28TQ User Manual page 72

Automatic
Recovery Time:
Web Refresh
Status:
Web Refresh
Interval:
Port Config

Status:
Operation Mode:
Recovery Mode:
Loop Status:
Block Status:
LAG:
Note:
Recovery Mode is not selectable when Alert is chosen in Operation Mode.
1.
To avoid broadcast storm, we recommend that you enable storm control before loopback
2.
detection is enabled.
Set the recovery time globally, after which the blocked port in
Auto Recovery mode can automatically recover to normal
status.
It should be integral times of detection interval. The value
ranges from 1-100 and is 3 by default
With this option enabled, the switch refreshes the web timely. By
default, it is disabled.
If you enabled web refresh, set the refresh interval between 3
and 100 seconds. The default value is 6 seconds.
Enable loopback detection for the port.
Select the operation mode when a loopback is detected on the
port:
Alert: The switch will display alerts. It is the default setting.

Port based: In addition to displaying alerts, the switch will

block the port on which the loop is detected.
If you select Port Based as the operation mode, you also need
to configure the recovery mode for the blocked port:
Auto: The blocked port will automatically recover to normal

status after the automatic recovery time. It is the default
setting.
Manual: You need to manually release the blocked port.

Click the Recovery button to release the selected port.
Displays whether a loop is detected on the port.
Displays whether the port is blocked.
Displays the LAG number the port belongs to.
61