Pim Sm Interface - TP-Link T3700G-28TQ User Manual

Features of BSR administrative domain:
Divide the BSR administrative domains by setting BSR border

Each BSR administrative domain has its own border, C-RP and BSR devices. These devices are
only valid in their belonged domains, which means that the BSR mechanism and RP election are
separated between their administrative domains.
BSR messages cannot pass through the BSR border

The multicast messages (such as C-RP Hello Message and BSR BootStrap Message) of each
BSR administrative domain cannot pass through the domain border.

11.4.1 PIM SM Interface

Choose the menu Multicast Routing→PIM SM→PIM SM Interface to load the following page.
The following entries are displayed on this screen:
PIM SM Interface Config

The L3 interfaces can be configured as PIM SM mode by this page.
Select:
Interface:
Status:
Hello Interval:
Join/Prune Interval:
DR Priority:
BSR Border:
IP Address:
Neighbor Count:
DR Address
Figure11-18 PIM SM Interface
Select the desired interface to configure.
Displays the VLAN interface which you can configure.
Select to enable or disable PIM SM function on the interface.
Specify the rate (time in seconds) at which PIM hello
messages are transmitted from the selected interface. The
valid value ranges from 1 to 18725 seconds and the default
is 30 seconds.
Specify the frequency at which PIM Join/Prune messages
are transmitted on this PIM interface. The valid value range
from 1 to 18724 seconds and the default value is 60
seconds.
Specify the DR priority for the selected interface. The valid
value range from 0 to 4294967294. The default value is 1.
Select to enable or disable the BSR border to define a PIM
bootstrap message boundary for the PIM domain.
Displays the IP address of the interface.
Displays the number of PIM neighbors of this interface.
Displays the DR address of the interface.
281