Firmware Upgrade Menu - ADTRAN IQ 710 System Manual

D >S L
IAL TAY ON EASED
Available for V.34, DCE, and BRI ISDN DBU modules when DBU is idle. The unit will remain on the
dedicated line and not attempt dial backup.
D >H U
IAL ANG P
Available for V.34, DCE, and BRI ISDN DBU modules when DBU is active. The option will disconnect
the current DBU session.
D >T O B
IAL URN FF EEP
Available for all DBU modules when DBU is active. This option will stop the audible beeper.
D >E D #
IAL NTER IAL
Available only for the PRI DBU module and only when DBU is active. This option will force the unit to
attempt dial backup to the phone number entered.
D >H U P
IAL ANG P HONE
Available only for the PRI DBU module and only when DBU is active. This option will disconnect the dial
backup session to the phone number entered.
D >H U S
IAL ANG P ITE
Available only for the PRI DBU module terminal interface and only when DBU is active. This option will
disconnect the dial backup session to a specific site. The site number may be obtained from the
M
menu.
ANAGER
D >H U A
IAL ANG P LL
Available only for the PRI DBU module and only when DBU is active. This option will disconnect all dial
backup sessions currently active.
F U
IRMWARE PGRADE
F U
IRMWARE PGRADE
The two methods for upgrading are XMODEM and TFTP. TFTP requires a TFTP server running on the
network. The IQ 710 starts a TFTP client function which gets the upgrade code from the TFTP server.
Selecting XMODEM will load the upgrade code through the Craft/Control port using any PC terminal
emulator with XMODEM capability.
F U
IRMWARE PGRADE
This is the IP address or domain name (if DNS is configured) of the TFTP server. Only available if Xfer
Method is set to TFTP.
F U
IRMWARE PGRADE
This is the file name which contains the upgrade code. Only available if Xfer Method is set to TFTP.
© 2002 ADTRAN, Inc.
#
#
C
ALLS
M
ENU
>X M
FER ETHOD
>TFTP S IP A
ERVER
>TFTP F
ILENAME
DDRESS
61202800L1-1B
Section 4, User Interface Guide
C
ALL
IQ 710 System Manual
IQ 710
Page 79