Updating The Firmware Of An Iq 710 Using Tftp - ADTRAN IQ 710 System Manual

UPDATING THE FIRMWARE OF AN IQ 710 USING TFTP

Introduction
The IQ 710 supports firmware updates via the
C /C port using XMODEM. This DLP provides the steps to follow for a successful firmware
RAFT ONTROL
upgrade using the E
THERNET
Tools and Materials Required
• A PC with a Telnet client software
• A TFTP Server accessible on the local network (A TFTP server is provided with the unit as part of the
ADTRAN Utilities software and may also be downloaded from the ADTRAN website at:
www.adtran.com.)
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, wear an antistatic discharge wrist strap to prevent damage to electronic
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
© 2002 ADTRAN, Inc.
E
THERNET
port and a TFTP Server.
Section 5, Detail Level Procedures
port using TFTP from a network server or via the
61202800L1-1B
IQ 710
Page 99
IQ 710 System Manual