ADTRAN IQ 710 System Manual page 48

61202800L1-1B
IQ 710
Section 4, User Interface Guide
Page 48
When configuring PVC options using the front panel the N
keys are used.
C >N
ONFIGURATION ETWORK
Enter the Network DLCI.
Range: 16 to 1007.
C >N
ONFIGURATION ETWORK
Enter the far end DLCI for each PVC used for dial backup. Only the IQ 710 that originates the call is
required to have this option set. These options are only available if a DBU card is installed.
The range for the DBU DLCI field is from 16 to 1007. Therefore, you cannot manually enter 0 for the
PVCs not used in DBU. When an entry is first created with the A
reset a previously configured DBU DLCI to 0, delete the entry and then add it back in (using the D
and A
selections).
DD
Only PVCs that are used in DBU should have the DBU DLCI set to a non-zero value.
C >N
ONFIGURATION ETWORK
The phone number entry stores the phone number that is used when the IQ 710 triggers auto DBU in case
of port or PVC failure. The phone number should correspond to a location that is equipped with an "Adtran
Safety Net" device that is capable of restoring the PVC which is designated by the DBU DLCI element.
If auto DBU is triggered by port failure, then the DBU Call Order element determines the order of a dialing
list for alternate backup locations.
These options are only available if a DBU card is installed. However, they are not available with the DCE
DBU card installed.
C >N
ONFIGURATION ETWORK
This determines the order in which a list of backup locations will be dialed. This applies only to auto dial
backup processes that are triggered by port failure. If all DBU Call Order entries are set to N
first entry with a DBU phone number will be used.
These options are only available if a DBU card is installed. However, they are not available with the DCE
DBU card installed.
C >N
ONFIGURATION ETWORK
This option works in conjunction with the dial backup criteria option W
IQ 710 System Manual
P >PVC O
ORT PTIONS
P >PVC O
ORT PTIONS
P >PVC O
ORT PTIONS
P >PVC O
ORT PTIONS
P >PVC O
ORT PTIONS
, P
EXT
> DLCI
> DBU DLCI
selection, it is set to 0 by default. To
DD
> DBU P N
HONE UMBER
>DBU C O
ALL RDER
> DBU I
ON NACTIVE
PVC I
ITH
, A , and D
REV DD ELETE
ELETE
, then the
ONE
. For the
NACTIVE
© 2002 ADTRAN, Inc.