ADTRAN IQ 710 System Manual page 186

61202800L1-1B
IQ 710
Section 6, Configuration Guides
Page 186
Huntsville IQ 710 (DCLI 20)
1. Using the left arrow, place the cursor over the number 2 (indicating entry 2) to the left of the DLCI
field; then press
2. Now add the DLCI to the Birmingham site. Use the right arrow to select DLCI; then press
Type in 20 and press
3. Use the right arrow to select DBU DLCI; then press
Notice that the TELCO-assigned DLCI of 20 for Huntsville's Frame Relay link to Birmingham is
programmed in the DLCI field. The TELCO-assigned DLCI of 21 for Birmingham's Frame Relay
link to Huntsville is programmed in the
dial backup operation.
4. Use the right arrow to select DBU P
press . The phone number that the Huntsville IQ 710 will dial to reach the Birmingham
<Enter>
IQ 710 to establish a dial backup connection has now been programmed.
5. Use the right arrow to select C
the table to be prioritized in the event that multiple PVCs are lost at once. Dial backup will first be
attempted on the PVC with the lowest Call Order that meets the DBU Criteria settings. Set this Call
Order to 1.
6. Use the right arrow to select DBU O
then press
<Enter>
IQ 710 System Manual
for insert. This should add an entry as shown in Figure 21.
<I>
Figure 21. New Entry Screen
.
<Enter>
HONE
O
ALL RDER
I
N NACTIVE
.
. Type in 21 and press
<Enter>
DBU DLCI field. These two entries are critical for proper
N ; then press
<Enter>
UMBER
. DBU C
N O
UMBER ALL
; then press
<Enter>
<Enter>
. Type in 12055553000 and
allows each DLCI listed in
RDER
. Down arrow to select G
© 2002 ADTRAN, Inc.
.
<Enter>
.
;
ROUP