ADTRAN IQ 710 System Manual page 258

61202800L1-1B
IQ 710
Section 6, Configuration Guides
Page 258
ISDN Options
1. From the screen shown in Figure 13, press the down arrow to select ISDN O
shown in Figure 14 is now displayed. The default values for the parameters on this menu are
shown.
2. Use the right arrow to select S
displayed. The S
service. Select LUCENT 5ESS, DMS 100, N
ple network in Figure 1, we will assume the switch type for all IQ 710 DBU units is N
Down arrow to select N
3. Down arrow to select B-C
press <Enter>. Generally leave this value to its default of 64
provides 56kbps.
4. Down arrow to select the N
single channel service or 2 for dual channel service and press
pany has given you two SPIDs, you should set the N
5. Down arrow to select SPID1; then press
Company for the first B-channel and press
proper SPID is entered here depending upon which IQ 710 is being configured.
6. Down arrow to select SPID2; then press
Company for the second B-channel and press
IQ 710 System Manual
Figure 14. ISDN Options Menu
T
WITCH YPE
T selected here must match the TELCO CO switch providing the ISDN
WITCH YPE
; then press
ATIONAL
B R
HANNEL IT ATE
B-C
UMBER OF
; then press . A list of available switch types is
<Enter>
, or NEC and press
ATIONAL
.
<Enter>
; then press . Select 54
<Enter>
KBPS
on the BRI line; then press
HANNELS
<Enter>
B-C
UMBER OF
. Enter the SPID assigned by the Telephone
<Enter>
. For the example network in Figure 1, the
<Enter>
. Enter the SPID assigned by the Telephone
<Enter>
. Again, for the example network in
<Enter>
. The screen
PTIONS
. For the exam-
<Enter>
ATIONAL
or 64
KBPS KBPS
unless your ISDN service only
. Enter 1 for
<Enter>
. If your Telephone Com-
to 2.
HANNELS
© 2002 ADTRAN, Inc.
.
and