Table of Contents
Related Manuals for ADTRAN ISU 512
Summary of Contents for ADTRAN ISU 512
- Page 1 ISU 512 ISDN Service Unit USER MANUAL Part Number ISU 512 (U Interface) 1202086L1 ISU 512 ST (ST Interface) 1202086L2 RS-530 to V.35 Adapter 1200072L1 RS-366 Y Cable 1200120L1 RJ-45 to DB-25 Adapter 3196.ADPT003 61202.086L1-1B September 1997...
- Page 2 Trademark: 5ESS is a registered trademark of AT&T DMS-100 is a trademark of Northern Telecom, Inc. ISU is a trademark of ADTRAN, Inc. 901 Explorer Boulevard P.O. Box 140000 Huntsville, AL 35814-4000 Phone: (205) 963-8000 © 1997 ADTRAN, Inc. All rights reserved.
- Page 3 4. If experiencing difficulty with this equipment, please contact ADTRAN for repair and warranty information. The telephone company may require this equipment to be disconnected from the network until the problem is corrected, or it is certain the equipment is not malfunctioning.
-
Page 4: Federal Communications Commission Radio Frequency Interference Statement
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT 1202086L1 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec- tion against harmful interference in a residential environment. -
Page 5: Canadian Emissions Requirements
CANADIAN EMISSIONS REQUIREMENTS 1202086L1 This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled "Digital Apparatus," ICES-003 of the Department of Communications. Cet appareil nuerique respecte les limites de bruits radioelectriques applicables aux appareils numeriques de Class B prescrites dans la norme sur le materiel brouilleur: "Appareils Numeriques,"... - Page 6 CANADIAN EQUIPMENT LIMITATIONS Notice: The Canadian Industry and Science Canada label identifies certified equip- ment. This certification means that the equipment meets certain telecommunications network protective, operational, and safety requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction. Before installing this equipment, ensure that it is permissible to be connected to the fa- cilities of the local telecommunications company.
- Page 7 LDN2 5551213 To configure the ISU 512 from the front panel press Enter from the initial sta- tus screen and continue entering the appropriate numbers until the Switch type, SPIDs and LDNs have been entered. (Note: Outside the U.S. and Canada, you will not need to enter SPIDs.)
-
Page 8: Maximum Bandwidth
Line 4 512 kbps SPID8/LDN8 To configure the ISU 512 using the VT 100 terminal interface, use the following procedure: Connect a VT 100 async terminal, or personal computer with a terminal emulator package, to the Chain In port using an RJ-45 cable and the RJ-45 to DB-25 adapter (part number 3196.ADPT003). - Page 9 Table of Contents Chapter 1. Understanding ISDN and the ISU 512 ............. 1 ISDN Overview ........................1 Product Overview ......................1 ISU 512 Interoperability ....................4 Recommended Operating Protocols................5 Chapter 2. Ordering ISDN....................7 Chapter 3. Installation ....................9 Installation...........................
- Page 10 Maintenance Setup ...................... 37 Auto Traps...................... 37 ADLP Address ....................37 Port Mode ....................... 37 Call NumID ........................38 Configuring the ISU 512 for Leased Digital Service............39 Clock Mode........................39 Channel Rate ........................ 40 Test Remote ........................41 Maintenance Setup ...................... 41 Auto Traps......................
- Page 11 Redial Last Number ....................54 Answer Call........................54 Dial Stored Number ....................54 Store/Review Number ....................55 Configuring the ISU 512 for V.25 bis In-band Dialing..........56 Chapter 6. Testing ......................57 Test Options ........................57 Loopback DTE......................57 Loopback Protocol....................... 57 2047 Checker ........................
- Page 12 Table of Contents Rate Adaption ....................67 Interoperability ....................67 D Channel Switch Compatibility ..............68 B Channel Aggregation ................68 Display ......................68 Environmental ....................68 Physical ......................68 Power....................... 68 Appendix A. Status Buffer Messages ................69 Appendix B. S-Register List ................... 79 Appendix C.
- Page 13 List of Figures Figure 1-1: ISU 512 Rear Panel ..................2 Figure 1-2: ISU 512 (U interface) Applications ............4 Figure 3-1: Maintenance Port VT 100 Menu ............... 12 Figure 3-2: VT 100 Configuration Menu ..............15 Figure 3-3: VT 100 Configuration Menu 2 ..............15 Figure 3-4: VT 100 Status Screen ..................
- Page 14 Table of Contents 61202.086L1-1 User Manual 61202.086L1-1...
-
Page 15: List Of Tables
List of Tables Table 1-A: ISU 512 Synchronous Rates ..............5 Table C-A: AT Commands .................... 85 Table D-A: Pinouts for Chain In and Chain Out Ports ..........89 Table D-B: Pinouts for IFC RJ-45 Connectors ............90 Table D-C: RS-366 Dialing Port Pinouts ..............91 Table D-D: RS-530 Pinouts .................... - Page 16 Table of Contents viii 61202.086L1-1 User Manual 61202.086L1-1...
-
Page 17: Understanding Isdn And The Isu 512
™ nects data terminal equipment (DTE) to the ISDN network or to a leased digi- tal network for data transmission. The ISU 512 is a basic inverse multiplexer that provides cost-effective high-speed data transmission for a single applica- tion at rates up to 512 kbps. - Page 18 ISDN terminal adapters. The ISU 512 is in- tended to support the transfer of data and images over ISDN. The ISU 512 has four RJ-45 jacks available on the rear panel for network con- nection (see Figure 1-1).
- Page 19 (as in a limited distance modem or leased line application) with no dialing necessary. The ISU 512 is designed to operate in a dual-port mode for videoconferencing at 112/128 kbps. This allows end-to-end compatibility when communicating with a video system that is utilizing two Switched 56 DSUs or a dual-port ISDN terminal adaptor.
-
Page 20: Isu 512 Interoperability
ADTRAN T1 DSU/CSU, TSU 100, OR TSU 600 Figure 1-2 ISU 512 (U interface) Applications The ISU 512 (ST interface) will also support these configurations but will require an external NT1 for each BRI line. ISU 512 User Manual 61202.086L1-1...