ADTRAN IQ 710 System Manual page 297

The N-Formant options are displayed in an expanding tree structure in the navigation panel at the upper
left. As selections are made in the navigation panel, the corresponding data windows are displayed in the
area on the right. If the resulting data window requires the user to specify additional indices, such as select-
ing a specific port or PVC, the required list is displayed in the index panel located below the navigation
panel. The data in the index panel can appear as either a tree structure or a table by selecting the desired tab
at the bottom of the panel.
The location of the navigation and index panels can be set by choosing from the
menu or the panels can be dragged anywhere within the N-Formant window.
RATION
By default the data windows being displayed on the right will stack on top of each other. This behavior can
be changed by selecting another standard behavior such as tiling, cascading, or other arrangement from the
P > W
REFERENCES INDOWS
N-Formant window.
The data windows present a variety of configuration, status monitoring, and diagnostic information about
the unit. Changes made in a particular window can be applied to the unit by clicking the buttons on the but-
ton bar at the top of the window. Click the
desired change to the unit and continue editing in the same window. Choose
and close the current window, or choose
3. MENU DESCRIPTIONS
As shown in the previous figure, menus are available for the basic IQ 710 device and for a dial backup
card. A brief discussion of each area and the menu options available follows.
D M
EVICE ENUS
The IQ 710 menu is divided into four main areas:
D
EVICE
. Each of these menus may be expanded by clicking on the desired option.
MANCE
D >S
EVICE TATUS
The menu contains statistics for the following five categories:
S
TATUS
,
S DTE S
TATUS TATUS
The DSX-1 S
© 2002 ADTRAN, Inc.
menu. The windows can also be dragged and resized anywhere within the
A
PPLY
C
ANCEL
, , and
DSX-1 S PVC L
TATUS
option appears only if the T1/DSX-1 card is installed.
TATUS
button or choose
F > A
ILE
to ignore the changes and close the window.
,
S C
TATUS ONFIGURATION
as shown in Figure 2 on page 298).
(
IST
61202800L1-1B
Section 7, N-FormAnt
P > C
REFERENCES
menu option to apply the
PPLY
D to apply the changes
ONE
, , and
T P
EST ERFOR
,
S I N
YSTEM NFORMATION
IQ 710 System Manual
IQ 710
Page 297
-
ONFIGU
-
ETWORK