ADTRAN IQ 710 System Manual page 253

DBU Criteria
1. From the screen shown in Figure 6, press the down arrow to select DBU C
screen shown in Figure 7 is displayed. The default values for the parameters on this screen are
shown.
Huntsville IQ 710
W N F
ITH ETWORK AILURE
1. Use the arrow keys to select the W
2. Use the down arrow to select E
3. The W N LMI parameter is enabled by default. Leave this option enabled.
ITH O
4. Press the down arrow to select W
5. Use the down arrow to select E
This is a global setting that affects all of the PVCs in the IQ 710 DLCI table (under
). A PVC is advertised as Inactive by the frame switch in the CO when there is a problem
O
PTIONS
at the remote end of the frame circuit. With this option enabled, the IQ 710 unit will attempt to
establish a dial backup call with the remote unit when its corresponding DLCI is advertised as
Inactive.
© 2002 ADTRAN, Inc.
Figure 7. DBU Criteria Menu
is disabled by default.
N
ITH
; then press
NABLE
PVC I
ITH
; then press
NABLE
F ; then press
ETWORK AILURE
.
<Enter>
; then press
NACTIVE
.
<Enter>
61202800L1-1B
Section 6, Configuration Guides
. The menu
RITERIA
.
<Enter>
.
<Enter>
N
ETWORK
IQ 710 System Manual
IQ 710
Page 253
PVC