Controller; Controller Configuration - Kontron PC/104-PCMCIA-1 User Manual

Kontron

CONTROLLER

5.
The Vadem VG-469 is a highly integrated PCMCIA controller. It is register compatible to the
Intel® 82365SL. Supporting two PCMCIA slots, it is uniquely designed for space-limited,
cost-sensitive applications in which battery life is an important factor. The VG-469 supports
the system bus timing used in standard ISA architectures.
On the PC/104-PCMCIA-1 the Vadem VG-469 provides the following functions:
Complies with PCMCIA 2.1/JEIDA 4.1
Supports memory and I/O cards
Supports PCMCIA-ATA specification
Supports 3.3V and 5V ISA bus interfaces
Supports standard PCMCIA cards (5V) only

Controller Configuration

5.1
The Vadem controller can be configured for two I/O addresses (3E0hex or 3E2hex). If the
PC/104-PCMCIA-1 is equipped with an onboard voltage regulator LT 11173, it also can be
configured for 3.3V PCMCIA cards. However, the standard board does not offer this feature
and can only support 5V PCMCIA cards.
Hardware jumpers control the configurations. See the table below for jumper settings and
also refer to the Appendix D: Connector Layout for jumper locations.
Jumper
JP101 I/O address setting:
(1-2) set → I/O address 3E0hex
(2-3) set → I/O address 3E2hex
JP403 PCMCIA card supply voltage:
(1-2) set → supply voltage 3.3V
(2-3) set → supply voltage 5V
JP404 PCMCIA card supply voltage:
(1-2) set → supply voltage 3.3V
(2-3) set → supply voltage 5V
More PCMCIA controller configurations are done using PCMCIA software (Socket and Card
Services) or the operating system. Please see the software documents for more details
about configuring and changing settings.
PC/104-PCMCIA-1 User's Guide
Assignment
Choose carefully to avoid
resource conflicts with
other devices in your
system.
On standard product the
3.3V feature is not
implemented.
DO NOT CHANGE!
On standard product the
3.3V feature is not
implemented.
DO NOT CHANGE!
9
Comments Default Settings
(1-2) set
(2-3) set
(2-3) set
Controller