6�18�- Programming Alarm : Digital Output T1 - Circutor CVM-E3-MINI-ITF Instruction Manual

6.18.- PROGRAMMING ALARM : DIGITAL OUTPUT T1
The values corresponding to digital output T1 are programmed in this step.
The code of the variable is selected on this screen, according to
, which will control digital output T1.
22
Press the
of the screen.
Press the
Set the value to 00 if you do not wish to program a variable.
When the desired value is shown on the screen, use the
cursor.
If an incorrect code has been entered, the value will be deleted and the device will restore the
last value saved.
To validate the value, press the
Parameter
Phase-Neutral Voltage
Current
Active power
Inductive Reactive Power
Capacitive Reactive Power
Apparent power
Power factor
Cosine φ
% THD V
% THD A
Phase-Phase Voltage
Frequency
Maximum current demand
Active Power Maximum
Demand
66
key for 3 seconds to enter the edit mode. The prog icon will flash on the left
key to modify the value of the flashing digit.
Table 20: Parameter codes used to program the digital output (Table 1)�
Phase
L1
L1
L1
L1
L1
L1
L1
L1
L1
L1
L1/2
-
L1
-
key for 3 seconds; the prog icon will stop flashing.
Code Phase Code
01 L2 09
02 L2 10
03 L2 11
04 L2 12
05 L2 13
06 L2 14
07 L2 15
08 L2 16
36 L2 37
39 L2 40
32 L2/3 33
31 - -
45 L2 46
- - -
CVM-E3-MINI
,
Table 20 Table 21
and keys to move the edit
Phase Code Phase Code
L3 17 -
L3 18 -
L3 19 III
L3 20 III
L3 21 III
L3 22 III
L3 23 III
L3 24 III
L3 38 -
L3 41 -
L3/1 34 -
- - -
L3 47 -
- - III
Instruction Manual
and
Table
-
-
25
26
27
28
29
30
-
-
-
-
-
42