Table of Contents
Advertisement
EncoreCX
Administrator's Manual
To program Loop Calling on system lines
All CO lines are programmed by default to use standard analog signaling. You can program your CO lines
to use Loop Calling if required. The benefit of having lines programmed for Loop Calling is that the line
will not be disconnected by the system if a digit is not dialed.
·
From the programming extension, press the PROGRAM Key.
·
Press the Scroll Down Key (î) until "System Programming" is displayed.
·
Select "System Programming".
·
Enter the System Programming Password and select "Lines".
·
Press the Scroll Down Key (î) until "PSTN Programming" is displayed.
·
Select "PSTN Programming".
·
Select "Loop Calling"
A menu showing the CO lines will be presented. The lines using Loop Calling are indicated by a "¨".
Those using the standard singling are indicated by a "à". Select the lines as required.
Press the Speaker Phone Key to finish programming.
Note: Last number Redial, Call Restriction, Saved Numbers, System and Personal Speed-Dial will not
work on the lines allocated as Loop Calling.
Programming Caller ID Detection
On standard CO lines on the EncoreCX, the "Caller ID Detection" option is programmed. The system can
then detect when Caller ID information is being sent from the network and display the number.
·
From the programming extension, press the PROGRAM Key.
·
Press the Scroll Down Key (î) until "System Programming" is displayed.
·
Select "System Programming".
·
Enter the System Programming Password and select "Lines".
·
Press the Scroll Down Key (î) until "PSTN Programming" is displayed.
·
Select "PSTN Programming".
·
Press the Scroll Down Key (î) until "Caller ID Detection" is displayed.
Select "Caller ID Detection" The lines with "Caller ID Detection" programmed are indicated with a "¨".
Press the Speaker Phone Key to finish programming.
Note: For this feature to operate Caller ID needs to be enabled by your telephone company.
Programming Tone Dialing
On standard CO lines on EncoreCX, the Tone dialing option is programmed. The system sends digits
dialed to the lines as tones rather than pulses.
·
From the programming extension, press the PROGRAM Key.
·
Press the Scroll Down Key (î) until "System Programming" is displayed.
·
Select "System Programming".
·
Enter the System Programming Password and select "Lines".
·
Press the Scroll Down Key (î) until "PSTN Programming" is displayed.
·
Select "PSTN Programming".
·
Press the Scroll Down Key (î) until "Tone Dialing" is displayed.
·
Select "Tone Dialing".
The lines with Tone Dialing programmed are indicated with a "¨".
Press the Speaker Phone Key to finish programming.
94
Advertisement
Table of Contents
