To Set The Call Logging Interface Speed For Connecting A Printer Or Pc; External Forwarding Options; Operation With A Parent Pbx - Inter-Tel encoreCX ECX 1000 Administrator's Manual

·
Enter the System Programming Password and select "Extensions".
·
Press the Scroll Down Key (î) until "No Call Logging" is displayed.
·
Select "No Call Logging".
·
Select the extensions whose calls are not to be logged. The selected extensions will be indicated with a
"¨".
Press the Speaker Phone Key to finish programming.

To set the call logging interface speed for connecting a Printer or PC

·
From the programming extension, press the PROGRAM Key.
·
Press the Scroll Down Key (î) until "System Programming" is displayed.
·
Select "System Programming".
·
Enter the System Programming Password and select "System".
·
Press the Scroll Down Key (î) until "Set v24 Baud Rate" is displayed.
·
Select "Set v24 Baud Rate".
·
Select the speed you require - 4800, 9600,19,200, 38,400 or 115,200 bps.
Press the Speaker Phone Key to finish programming.
Note: To connect a printer or PC for call logging, use the call logging cable provided and connect one end
to the V24 interface on the Central Control Unit (CCU) and the other end to the serial device, (e.g. a PC or
a printer.)

External forwarding Options

This allows you to decide if external callers or external and internal callers to your extension are forwarded
externally if you have set an external Forward. It also allows extensions to be prohibited from activating an
external forward.
·
From the programming extension, press the PROGRAM Key.
·
Press the Scroll Down Key (î) until "System Programming" is displayed.
·
Select "System Programming".
·
Enter the System Programming Password and select "Extensions".
·
Press the Scroll Down Key (î) until "External Forwarding" is displayed.
·
Select "External Forwarding".
·
Select "No Trunk To Trunk Calls".
·
Select the extensions that are not allowed to activate an external forward or set up trunk to trunk calls.
Press the Speaker Phone Key to finish programming.
If both internal and external calls are to be forwarded, select "All Calls".
If external calls only are to be forwarded, select "External Calls Only"

Operation with a parent PBX

You can connect the EncoreCX to a parent PBX via its line interfaces.
You can program any of the 11 Outgoing Groups to work with a parent PBX. When programming the
Outgoing Groups as PBX groups, PBX access digits and the number of digits in a PBX extension number
are entered. The PBX access digits are the digits that must be dialed to select a CO line in the parent PBX.
(You can have a maximum of two PBX access digits.)
If you wish to make an external call via the parent PBX, you must select a line connected to the PBX,
placing the access digit(s) before the external number you require. If you wish to make a call to a parent
85