To Change The Programming Extension; To Change The System Programming Password; To Configure Unequipped Line Interfaces - Inter-Tel encoreCX ECX 1000 Administrator's Manual

To change the Programming extension

System programming can only be carried out at one digital telephone set, that is, the digital telephone set
connected to the programming extension. By default, extension 20 is the programming extension. The
programming extension can be changed to any other extension if required, except for the PA extension.
·
From the programming extension, press the PROGRAM Key.
·
Press the Scroll Down Key (î) until "System Programming" is displayed.
·
Select "System Programming".
·
Enter the System Programming Password and select "System".
·
Select "Programming Position".
·
Select the extension you wish to have as the programming extension. The selected programming
extension is denoted by a "¨".
Press the Speaker Phone Key to finish programming.
Note: The PA extension will not appear on the display as an option for the programming extension.

To change the System Programming Password

The default System Programming Password (1111) can be changed to any four-digit number.
·
From the programming extension, press the PROGRAM Key.
·
Press the Scroll Down Key (î) until "System Programming" is displayed.
·
Select "System Programming".
·
Enter the System Programming Password and select "System".
·
Select "Change Password".
·
Select "System Password"
·
Select "Change" and enter the four-digit number you require.
·
Select "Confirm".
Press the Speaker Phone Key to finish programming.

To configure unequipped Line interfaces

The system assumes that available line interfaces have CO lines connected to them. If a line interface does
not have an CO line connected, ensure correct system operation by un-equipping the line interface in
System Programming, as follows:
·
From the programming extension, press the PROGRAM Key.
·
Press the Scroll Down Key (î) until "System Programming" is displayed.
·
Select "System Programming".
·
Enter the System Programming Password and select "Lines".
·
Press the Scroll Down Key (î) until "Equipped Lines" is displayed.
·
Select "Equipped Lines".
·
Select the lines you wish to equip or unequip. Equipped lines are denoted by a ♦. Unequipped lines are
denoted by a "à".
Press the Speaker Phone Key to finish programming.
87