Table of Contents
Advertisement
EncoreCX
Administrator's Manual
·
Select "System Programming".
·
Enter the System Programming Password and select "System".
·
Press the Scroll Down Key (î) until "Caller ID List" is displayed.
·
Select "Caller ID List".
·
Select "Store All calls" or "Store Unanswered Calls".
Press the Speaker Phone Key to finish programming.
To set up
s with an individual Caller ID List
extension
You can program up to 40 extensions to store ten numbers each. Each of these extensions will have a
separate record of calls that ring on CO Lines programmed to ring their extensions only.
·
From the programming extension, press the PROGRAM Key.
·
Press the Scroll Down Key (î) until "System Programming" is displayed.
·
Select "System Programming".
·
Enter the System Programming Password and select "Extensions".
·
Press the Scroll Down Key (î) until "Individual Caller ID Lists" is displayed.
·
Select "Individual Caller ID Lists".
·
Select the extensions that you wish to have an individual Caller ID List. The extensions that will have a
Caller ID List will have a "¨" displayed beside them.
Press the Speaker Phone Key to finish programming.
Paging
You can connect a Public Address (PA) amplifier to any extension on your EncoreCX. Users can then
make announcements over the PA. A PA Answer feature allows a user to respond directly to the paging
extension without having to know the extension number.
The system also allows users to make announcements over the speakers of all digital telephone sets, and to
make Single extension page calls to other users via the speakers of their digital telephone sets.
You can program the system to protect users' digital telephone sets against both announcements and Single
extension page Calls.
Another feature available is a "Page All" which will page both digital telephone sets and a PA
simultaneously. A PA must be installed to use this feature.
To program an extension for use with a Public Address amplifier
An extension with a Public Address amplifier connected must first be programmed for use with a PA
amplifier.
·
From the programming extension, press the PROGRAM Key.
·
Press the Scroll Down Key (î) until "System Programming" is displayed.
·
Select "System Programming".
·
Enter the System Programming Password and select "System".
·
Press the Scroll Down Key (î) until "PA Amplifier" is displayed.
·
Select "PA Amplifier".
·
Select "PA Equipped".
·
Select the extension to which PA system is connected.
Press the Speaker Phone Key to finish programming.
Note: The extension that has been programmed as the Programming extension will not be displayed as an
option on the screen.
44
Advertisement
Table of Contents
