Switching On The Instrument - R&S NGL200 Getting Started

®
R&S NGL200/NGM200
Digital voltmeter (DVM)
The DVM+ and DVM- pins on the channel connector are available only with
R&S NGM power supply series equipped with option R&S NGM-K104 (P/N:
3643.9927.02).
The channel connectors contain both output ("F+", "F-") and sense ("S+", "S-")
connections. Connector for "Ch2" is only available in the R&S NGL202, R&S
NGM202 models.
USB connectors (14, 15)
The USB host connector (Type-A) can be used for mass storage devices or an
external mouse like the USB connector at the front panel.
The USB device connector is a Type-B connector for remote control operation.
Ethernet connector (16)
10/100 Ethernet port for remote control operation via the local area network.
For a detailed description on the connection setup, see section "LAN Connection"
in the User Manual.
6.2

Switching on the instrument

Before switching on the instrument, check that all the instructions in the "Basic
Safety Instruction" brochure and safety measures in previous sections are
observed. Also, check if the value on the voltage selector corresponds to the
mains voltage (100 V, 115 V or 230 V).
Fuse rating
The R&S NGL/NGM uses the same fuse ratings for all mains voltages.
To change power fuse / mains voltage setting:
1. Peel off the yellow label sticker on the AC inlet.
2. Release the latch of the fuse holder which is located at both side of the socket
and pull it out.
Getting Started 1178.8720.02 ─ 07
Instrument tour
Switching on the instrument
24