Table of Contents
Advertisement
Section 3
Unpacking and Installation
Pre-startup Check
Connecting to Main
Power Supply
3-2
Hotplate & Magenetic Stirrer
•
Check the unit is balanced well.
•
Never install or use this instrument with or near to hazardous or
flammable substances.
•
Do not install this instrument near any device that generates high
frequency noise.
•
Do not install with short circuit, water leak, and risk of flooding places.
•
Do not install with industrial harmful gas, metal dirt environments.
When connecting power, use only the power cord that came with your
instrument. The power connection procedures are as follows:
(1) Before connecting the power cord, make sure that the main power
switch is turned off.
(2) Plug the power cord into the power socket at the back of your
instrument as shown in the diagram below.
(3) Plug the other end into a properly grounded and dedicated power
outlet nearby.
Electrical Shock Hazard.
• Check voltage, phase and capacity of power supply and connect properly.
• Do not insert damaged line cord or multiple plugs into outlet at the same
time.
• DO NOT use without safety PPE (working clothes, gloves, glasses)
• DO NOT handle or touch electrical cord or electrical parts with wet hands.
• Make sure to connect this instrument only to properly grounded power outlets
to protect you and your instrument.
Thermo Scientific
Advertisement
Table of Contents
