Connecting The Fraction Collector; Connecting The External Desktop Power Supply - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

3.4 Connecting the Fraction Collector

The next steps in the installation process involve connecting the AFC-3000 to the power
source and to the Chromeleon computer. The following sections explain how to establish
these connections.

3.4.1 Connecting the External Desktop Power Supply

A voltage-specific external desktop power supply is delivered with each AFC-3000.
Use the external desktop power supply shipped with the fraction collector to connect the
instrument to the main power source:
1. Place the AFC-3000 within 1.2 meters of a power outlet.
2. Connect the external desktop power supply to the DC power input connector on the
rear panel of the fraction collector (→ Fig. 3, page 19).
3. Connect the supply side of the power supply to the power source that is connected to a
true ground.
The input rating is AC 100V-240V 1.9 A with an output of DC 24V, maximum 3.33 A. No
manual adjustment is required to adapt the line voltage to local voltage requirements.
Warning:
Avertissement: Utilisez uniquement les cordons d'alimentation électrique spécifique
Important:
Important:
Operating Instructions
Never use a power cord other than the power cords provided for the
device.
Do not use multiple sockets or extension cords. Using defective
multiple sockets or extension cords may cause personal injury or
damage to the device.
à l'instrument.
N'utilisez pas des blocs multiprise ou des câbles prolongateurs. Cela
pourrait entraîner des blessures corporelles ou endommager
l'instrument.
The AFC-3000 is intended to operate from an AC power source that
will not apply more than 240V AC between the supply conductors
and ground. A protective ground connection by way of the
grounding connector in the power cord is required for safe operation.
L'AFC-3000 est destiné à fonctionner d'une source d'alimentation
courant alternatif qui s'appliquera pas plus que 240V courant
alternatif entre le conducteur et la terre. Une connexion de protection
à la terre par le fil neutre dans le fil d'alimentation est nécessaire
pour la sécurité d'exploitation.
UltiMate 3000 Series:
AFC-3000 Automated Fraction Collector
Page 35