Changing The Low Temp Limits (T-L) - Thermo Scientific HPS RT2 Advanced Manual

Changing High Temp
Limits (t-H) cont.
Changing the Low
Temp Limits (t-L)
Thermo Scientific
If you don't want to save it, press the Stirrer Knob when display shows
"SAVE NO". [When you don't need to save the changes]
Step 5 : Terminate the configuration mode as describe in Configuration
Mode.
• The allowed range of the temperature limit setting is 0°C ~ 350°C.
• After terminating the configuration modes, new temperature setting should
be arranged within the range of the temperature limit.
Note that the default setting of the low temperature limit [t-L] 0°C. If
needed, however, you can set your own temperature limits. If, for example,
you want to set the high temperature limit at 100°C, do as follows:
Step 1 : Press the CONFIG Button.
Step 2 : Select the temperature limit mode shown
below by turning the Stirrer Knob. Press the Stirrer Knob and check the
current low temperature limit:
Step 3 : Change the limit to the desired value by turning the Stirrer Knob.
Section 4
Control Panel
Digital Hotplate 4-21