Temperature Unit Conversion (°C ↔ °F); Configuration Mode - Thermo Scientific HPS RT2 Advanced Manual

Section 4
Control Panel

Configuration Mode

Temperature Unit
Conversion (°C ↔ °F
4-14 Digital Hotplate
Various configuration settings can be adjusted under the configuration
mode such as heating mode, timer mode, maximum heating rate, low and
high temperature limits, temperature unit, temperature offsetting,
temperature control mode, and so on.
You can enter this configuration mode by pressing the CONFIG Button
when the unit is properly connected to a power outlet but not operating.
You can terminate the configuration mode by using one of the following
methods:
Step 1 : Press the RUN/STOP Button.
Step 2 : Turn the stirrer knob to select YES and push it to confirm the ter-
mination as shown below.
Or turn the stirrer knob clockwise until you get the following ESC display
and then push it to confirm the termination as shown below:
Note also that the configuration mode is automatically terminated if there
is no button operation for more than 20 seconds.
You can select the desired temperature unit as follows:
Step 1: Press the CONFIG Button
Step 2: Select the temperature unit conversion by
turning the Stirrer Knob as shown below.
Thermo Scientific