Temperature Setting During Operation - Thermo Scientific HPS RT2 Advanced Manual

Temperature Setting
(continued)
Temperature Setting
During Operation
Thermo Scientific
Step 3: Push the RUN/STOP Button.
Heater LED will be on and heater will be activated.
If the external temperature probe is connected, the temperature which
probe detects will be displayed. If not, top plate's temperature will be
displayed.
• Changing the temperature setting is allowed only within the low and high
temperature limits. If changing the temperature setting cannot be done prop-
erly, check the low and high limits first. (Refer to Check the Configuration
Settings)
• You can set the low and high temperature limits at any value between 0°C
and 350°C.
Press TEMP Button or the Heater Knob during operation to see the set
temperature.
If you press TEMP Button, set temperature is shown on the right. After 15
seconds, the mode will be escaped automatically.
If you press the Heater Knob, set temperature is shown on the left. After 3
seconds, the mode will be escaped automatically.
Section 4
Control Panel
Digital Hotplate 4-7