Timer Setting - Thermo Scientific HPS RT2 Advanced Manual

Section 4
Operation

Timer Setting

4-10 Digital Hotplate
This unit provides two types of timer mode: immediate timer activation
and delayed timer activation. (For selecting the timer mode, Refer to 4.3.2
Selection of the Timer Mode)
[Indicating LED status during timer is activating]
You can stop timer by pushing RUN/STOP Button during timer's
activation. For both timer modes, the timer setting procedures are the
same:
Step 1: Press the Timer Button to begin the timer setting and also to check
the display showing the current timer setting. Note that the hour frame
is blinking first as shown below.
Step 2: If you want to change the timer setting, select and then save the
desired values into the hour frame and the minute frame by turning the
Stirrer Knob and pushing it for confirmation as shown below.
Step 3: Now, the unit will display the set temperature for verification as
shown below. Turn the Stirrer Knob to select the desired value and then
press it for confirmation. The following display will appear momentarily.
[If you change the set temperature]
Thermo Scientific