Auto-Tuning (Pid Parameter Calibration) - Thermo Scientific HPS RT2 Advanced Manual

Check Configuration
Settings (LISt) cont.
Auto-tuning (PID
Parameter Calibration)
Thermo Scientific
The default configuration settings are as follows:
MODE Default Setting
Unit Cels
OFST/OFSP 0.0
t-H 350.0
Coef Opti
Step 4 : After checking the settings, terminate the checking mode. [Either
by pressing RUN/STOP Button]:
[Or by pressing the Stirrer Knob]:
Step 5: Terminate configuration mode as described in Configuration
Mode.
The PID parameters for temperature control can be automatically tuned to
take your specific operating circumstances into consideration.
If you select User Mode [Coefficient], the unit will be operated with the
auto tuning value.
The auto-tuning (calibration) procedures are as follows:
Step 1 : Press the CONFIG Button.
Step 2 : Select the auto-tuning mode [CALi] shown
below by turning the Stirrer Knob.
MODE Default Setting
Time ti1
Limt 100.0
t-L 0.0
Mmin 1
Digital Hotplate
Section 4
Control Panel
4-23