Configuring The Sp; List Of Configuration Commands; Configuration Command Setting Example - Hitachi GX1000-SMC013X Instruction Manual

12.2 Configuring the SP

12.2.1 List of configuration commands

The following table lists the commands used to configure the SP functionality.
Table 12- - - - 1 1 1 1 List of configuration commands
Table 12 Table 12 Table 12
Command name
sp-port
peer-control vlan
peer-control ip
peer-control ipv6

12.2.2 Configuration command setting example

The following example shows how to use the configuration commands.
(1) Configuring for the communication between CSU and SP
Overview
To set the SP firmware, set the SP connection line and Tag-VLAN and IPv4
addresses.
Configuration command example
(config)# sp-port 1/3
1.
Specify port number 3 of NIF number 1 for the SP connection line to enter SP
administrator mode.
(config-sp)# peer-control vlan 10
2.
Set VLAN 10 for control traffic Tag-VLAN.
(config-sp)# peer-control ip 192.168.30.20 255.255.255.0
3.
Set IPv4 address 192.168.30.20 and subnet mask 255.255.255.0 for the control
traffic on the SP.
Description
Sets the line connected to the SP.
Sets the Tag-VLAN on the SP for control traffic of the SP connection line.
Sets the IPv4 address on the SP for control traffic of the SP connection line.
Sets the IPv6 address on the SP for control traffic of the SP connection line.
183