Hitachi GX1000-SMC013X Instruction Manual page 129

| own-address} | any | own | range-address
ipv4>
<destination ipv4 end>
Specifies the destination IPv4 address.
To specify all destination IPv4 addresses, specify
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify <destination ipv4> <destination ipv4
any
ipv4>,
own range-address
, or
Specify the destination IPv4 address for
For <destination ipv4
format that specifies bits in an IPv4 address whose permitted value is
arbitrary.
host
If <destination ipv4>
<destination
any
If is specified, the destination IPv4 address is not used as a filter
condition.
own-address
interface.
range-address
interface or a VLAN interface.
own-address
If
that has been set on the target interface.
own
If is specified, the filter condition is the network address part of the IPv4
address that has been set on the target interface. The host address part of the
IPv4 address in the filter condition is assumed to be arbitrary.
If the interface with the
multihomed, the primary IPv4 address is assumed.
range-address
If
<destination ipv4 start>
Specify IPv4 addresses so that
<destination ipv4
IPv4 address (nnn.nnn.nnn.nnn): 0.0.0.0 to 255.255.255.255
{ /
<destination ipv6> <length>
own-address
<own address length>
<destination ipv6 end>
Specifies the destination IPv6 address.
To specify all destination IPv6 addresses, specify
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify <destination ipv6>
host
<destination
<destination ipv6 start> <destination ipv6
Specify the destination IPv6 address for
For <length>, specify the part of the IPv6 address that is to meet the
}
own-address
, <destination ipv4
<destination ipv4 start> <destination ipv4
wildcard>, specify a wildcard mask in IPv4 address
is specified, the filter condition is an exact match of
ipv4>.
own
and are valid only for
is valid only for
is specified, the filter condition is the destination IPv4 address
own-address
is specified, the filter condition is in the range from
to <destination ipv4
start>.
| host {
<destination ipv6>
| own | range-address
}
/
<length>,
host own-address
ipv6>,
<destination ipv4 start>
any
.
wildcard>,
wildcard>,
<destination
access-group
access-group
commands for an Ethernet
own
or parameter specified is
end>.
<destination ipv4 end>
| own-address} | any |
<destination ipv6 start>
any
.
own-address
<own address
any own
, ,
end>.
<destination
host
<destination
host own-address
,
end>.
ipv4>.
commands for a VLAN
is larger than
length>,
range-address
, or
ipv6>.
129