Hitachi GX1000-SMC013X Instruction Manual page 308

ping6
Description
This command sends ICMP ECHO_REQUEST packets to a host on the network. (For IPv6
only)
Input mode
SP user mode and SP administrator mode
Syntax
ping6
X:X::X:X
Parameters
: :: :
X X X
Specifies the destination IPv6 address.
count
INT
Sends packets for the number of times specified for INT, and then finishes the
processing. The specifiable values are from 1 to 900000.
When this parameter is omitted:
The command sends packets four times.
maxhop
Sets the value specified for
distributed. The specifiable values are from 1 to 255.
When this parameter is omitted:
The command sets the maximum number of hops to which data is distributed to 64.
from :
X
Specifies the source IPv6 address.
datasize
Specifies how many bytes of data are to be sent. The specifiable values are from 64
to 65468.
When this parameter is omitted:
This command sets the number of bytes to 64.
Display example:
SP01> ping6 192:168:100::100
PING 192:168:100::100 (192:168:100::100): 56 data bytes
64 bytes from 192:168:100::100: icmp_seq=0 ttl=64 time=1.9 ms
64 bytes from 192:168:100::100: icmp_seq=1 ttl=64 time=1.6 ms
64 bytes from 192:168:100::100: icmp_seq=2 ttl=64 time=1.6 ms
64 bytes from 192:168:100::100: icmp_seq=3 ttl=64 time=1.6 ms
--- 192:168:100::100 ping statistics ---
4 packets transmitted, 4 received, 0% loss, time 3000ms
rtt min/avg/max/mdev = 1.634/1.672/1.687/0.036 ms
SP01>
Notes
To stop execution of the
308
[count INT] [maxhop INT] [from X:X::X:X] [datasize INT]
X
INT
:: :
X X X
INT
INT as the maximum number of hops to which data is
ping6
command, press Ctrl+C.