Updating Files; How To Update The Files - Hitachi GX1000-SMC013X Instruction Manual

19.5 Updating files

This section describes how to update SP files.

19.5.1 How to update the files

1. Prepare an FTP server, and then save the files to be updated on the server.
Example of a file to update:
2. Add the server to the SP configuration and the CSU configuration so that the FTP
server is accessible from the update-target SP interface specified by using the CSU
configuration command
3. In the CSU terminal, go from CSU administrator mode to administrator mode for the
SP to be updated.
4. Use the
Display example (
(SP
[update] Using /dev/sda1 for update
importing file ftp://debug@192.168.0.1/SP/RELEASE/NXSC0312.1279
Password:
Upgrade start.
Upgrade complete, you need to restart this card.
5. Use the
Startup ver
Display example:
(SP
Date 2011/01/12 01:24:04
F/W:
Current : Startup
Active
Startup ver. 1.2 build_1279
Backup
H/W:
BOOT
MISC
SPCT
6. Go from SP administrator mode to CSU administrator mode.
7. Execute the
8. After the SP starts, go from CSU administrator mode to administrator mode for the
SP to be updated.
9. Use the
Startup ver
Display example:
(SP
Date 2010/01/12 01:35:07
F/W:
Current : Startup
Active
Startup ver. 1.2 build_1279
Backup
228
NXSC0312.1279
Update version number
SP-port
update
command to specify the files to be updated and then update the SP.
ftp
command):
name)# update ftp://debug@192.168.0.1/SP/RELEASE/NXSC0312.1279
show version
command to check whether the update was applied to
.
name)# show version
ver. 1.0 build_1176
ver. 1.0 build_1176
[11.44]
[1.0]
[0.34]
inactivate nif
show version
command to check whether the update was applied to
.
name)# show version
ver. 1.2 build_1279
ver. 1.0 build_1176
and its subordinate command
activate nif
and commands for the SP to restart it.
peer-control
.