Hitachi GX1000-SMC013X Instruction Manual page 282

show interface
Description
This command displays Ethernet information.
Input mode
SP user mode and SP administrator mode
Syntax
show interface [INTERFACE [statistics [{detail|update INT}]]]
Parameters
When this parameter is omitted
Displays Ethernet information for all registered interfaces.
INTERFACE
Displays information about the specified interface.
If the specified interface is in the Link Down status, no information is displayed.
statistics
Displays statistics on the interface packets
detail
Displays detailed statistics on the interface packets
update INT
Updates the display based on the number of seconds specified for int. Use Ctrl+C to
finish.
Display example:
SP01> show interface bnet0
bnet0: <BROADCAST,MULTICAST,UP,RUNNING> <INFRA> mtu 1500 qdisc noqueue
link/ether mode virtual 02:09:c0:17:79:4e brd ff:ff:ff:ff:ff:ff
blade 1 cpblade 1 portuid 0x00100000
IPv4 forwarding: on IPv6 forwarding: on
IPv4 force reassembly: yes IPv6 force reassembly: yes
inet 172.32.202.1/24 brd 172.32.202.255 scope global xmsd bnet0
inet6 fe80::9:c0ff:fe17:794e/64 scope link
valid_lft forever preferred_lft forever
SP01>
To display statistics on the interface packets:
SP01> show interface bnet0 statistics
statistics:
Kernel Interface table
Iface
bnet0
SP01>
282
MTU Met RX-OK RX-ERR RX-DRP RX-OVR
1500 0 57
TX-OK TX-ERR TX-DRP TX-OVR Flg
0 0 0 48 3 0 0 BMRU