arp/ndp
Description
This command sets whether to enable or disable the ARP and NDP of the relevant
interface.
Execute this command in the
Syntax
To set or change information:
arp/ndp {enable|disable}
Parameters
enable
Enables the ARP and NDP of the interface.
1.
2.
disable
Disables the ARP and NDP of the interface.
1.
2.
Notes
The default for initial installation is
264
ethernet
Default value when this parameter is omitted:
None (this parameter cannot be omitted).
Range of values:
enable
Default value when this parameter is omitted:
None (this parameter cannot be omitted).
Range of values:
disable
level of configuration definition mode.
enable
.