Hitachi GX1000-SMC013X Instruction Manual page 116

layer2-forwarding
Specifies the forwarding type to be detected in flow detection.
layer2-forwarding
This parameter has an effect only when it is applied to an Ethernet interface.
1.
2.
layer2-and-layer3-forwarding
Specifies the forwarding type to be detected in flow detection.
layer2-and-layer3-forwarding
3 in flow detection.
This parameter has an effect only when it is applied to a VLAN interface.
1.
2.
Default behavior
None
Impact on communication
When an access list with at least one entry is applied to an interface, IP packets received at
the interface are discarded temporarily until the entry is applied to the interface.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. On an Ethernet interface, you can set one Advance access list for Inbound and one
Advance access list for Outbound.
If an Advance access list has already been set, first remove it and then set it again.
2. If you specify a non-existent Advance filter, this will be ignored. The identifier of the
Advance filter is registered.
3. You can set an Advance access list if the flow distribution pattern is
standard-advance
extended-advance
mac-ip
4. If
own
access list if an IPv4 address is set for the target interface.
mac-ipv6
5. If
own
access list if only one IPv6 global address is set for the target interface.
6. If an Advance access list is to be applied to an Ethernet interface and a VLAN
parameter is set in the flow detection condition, you can set the list if all VLAN IDs
corresponding to the VLAN parameters are included in the settings of the Ethernet
interface.
116
detects IP packets forwarded on Layer 2 in flow detection.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
None
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
None
default extended-advance
,
filter extended-advance
,
is specified for the flow detection condition type and the
parameter is specified in the flow detection condition, you can set an Advance
is specified for the flow detection condition type and the
parameter is specified in the flow detection condition, you can set an Advance
detects packets forwarded on Layer 2 and Layer
filter-only
,
qos extended-advance
, or
default
.
own-address
or
own-address
or