Hitachi GX1000-SMC013X Instruction Manual page 159

policy-switch-list
Sets items related to policy-based switching.
Entering this command switches to
list information for the relevant list number can be set.
A maximum of 1,000 items can be set for policy-based switching list information per device.
Input format
To set or change information:
policy-switch-list
To delete information:
no policy-switch-list
Input mode
(config)
Parameters
<policy switch list no.>
Specifies the list number of the policy-based switching list information.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. Policy-based switching list information that is being used by the access list cannot be
deleted.
2. Before specifying this command, set the route allocation pattern to
Related commands
permit (advance access-list)
policy-interface (policy-switch-list)
default (policy-switch-list)
recover (policy-switch-list)
policy-switch-list resequence
<policy switch list no.>
<policy switch list no.>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify 1 to 1,000 in decimal.
config-pol-sw
mode, in which policy-based switching
extended
.
159