Hitachi GX1000-SMC013X Instruction Manual page 141

Specify 0x0000 to 0xffff (hexadecimal) or the Ethernet type name.
For details about the Ethernet type names that can be specified, see Ethernet
type names that can be specified.
vlan { |
<vlan id> <vlan id list name>
Specify the VLAN ID or VLAN list name.
This parameter has an effect only when it is applied to an Ethernet interface.
1. Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2. Range of values:
Specify the VLAN ID or VLAN list name.
For details about the configuration, see 6.3 Specifiable values for parameters.
user-priority
<priority>
Specifies the user priority.
1. Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2. Range of values:
Specify 0 to 7 in decimal.
ctag-untagged
Specifies detection of packets with no customer tag.
1. Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2. Range of values:
None
ctag-user-priority
Specifies the user priority for the customer tag.
1. Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2. Range of values:
Specify 0 to 7 in decimal.
ctag-vlan
<vlan id>
Specifies a VLAN ID for the customer tag.
1. Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2. Range of values:
Specify 0 to 4,095 in decimal.
{ip | | icmp | igmp | tcp | udp}
<protocol>
You can select this parameter when
condition.
Specifies the upper-layer protocol condition for IPv4 packets.
Note that if all protocols are applicable, specify
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
}
<priority>
mac-ip
is specified as the flow detection
ip
.
141