Hitachi GX1000-SMC013X Instruction Manual page 249

icmp limit rate
Description
This command specifies the transmission interval for ICMP errors in the
configuration definition mode.
This command controls the interval for each combination of the source and destination IP
addresses of ICMP error packets.
Syntax
icmp limit rate { default |
Parameters
default
Sets the default minimum interval between ICMP error messages.
1.
2.
<milli seconds>
Specify the minimum interval between ICMP error messages. If you set 0, the
transmission of ICMP error packets is not limited by the transmission interval.
1.
2.
3.
Notes
None
Default value when this parameter is omitted:
None (this parameter cannot be omitted).
Range of values:
1000 (milliseconds)
Default value when this parameter is omitted:
None (this parameter cannot be omitted).
Range of values:
0 to 600000 (milliseconds)
Notes:
The set value is used after being rounded up to the nearest multiple of 4.
}
<milli seconds>
gen
level of
249