Hitachi GX1000-SMC013X Instruction Manual page 172

policy-list resequence
Resets the sequence in which routing information items for policy-based routing are
applied.
Input format
To set or change information:
policy-list resequence
sequence>
Input mode
(config)
Parameters
<policy list no.>
Specifies the list number of the policy-based routing list information.
1.
2.
<starting sequence>
Specifies the starting sequence number.
1.
2.
<increment sequence>
Specifies the increment value for the application sequence.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
policy-list
policy-interface (policy-list)
172
]]
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify 1 to 256 (in decimal).
Default value when this parameter is omitted:
The initial value is 10.
Range of values:
Specify 1 to 4,294,966,494 in decimal.
Default value when this parameter is omitted:
The initial value is 10.
Range of values:
1 to 100 in decimal.
[
<policy list no.> <starting sequence>
[
<increment