Hitachi GX1000-SMC013X Instruction Manual page 144

{{
<destination ipv4>
| own-address} | any | own | range-address
ipv4>
<destination ipv4 end>
Specifies the destination IPv4 address.
To specify all destination IPv4 addresses, specify
1.
2.
{
<destination ipv6>
own-address
<destination ipv6 end>
Specifies the destination IPv6 address.
To specify all destination IPv6 addresses, specify
1.
144
neq
If is specified, the filter condition is other than
range
If is specified, the filter condition is in the range from
to <source port end>.
Specify port numbers so that
start>.
| own-address}
}
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify <destination ipv4> <destination ipv4
any own-address
ipv4>, ,
own range-address
, or
Specify the destination IPv4 address for
For <destination ipv4
format that specifies bits in an IPv4 address whose permitted value is
arbitrary.
host
If <destination ipv4>
<destination ipv4>.
any
If is specified, the destination IPv4 address is not used as a filter
condition.
own-address own
and
interface.
range-address
is valid only for
interface or a VLAN interface.
own-address
If is specified, the filter condition is the destination IPv4 address
that has been set on the target interface.
own
If is specified, the filter condition is the network address part of the IPv4
address that has been set on the target interface. The host address part of the
IPv4 address in the filter condition is assumed to be arbitrary.
If the interface with the
multihomed, the primary IPv4 address is assumed.
range-address
If is specified, the filter condition is in the range from
<destination ipv4 start>
Specify IPv4 addresses so that
<destination ipv4 start>.
IPv4 address (nnn.nnn.nnn.nnn): 0.0.0.0 to 255.255.255.255
/ | host {
<length>
<own address length>
}
Default value when this parameter is omitted:
This parameter cannot be omitted.
<source port end>
<destination ipv4 wildcard>
<destination ipv4
<destination ipv4 start> <destination ipv4
<destination
wildcard>, specify a wildcard mask in IPv4 address
is specified, the filter condition is an exact match of
access-group
are valid only for
access-group
own-address own
or
to <destination ipv4
<destination ipv4 end>
<destination ipv6>
| own | range-address
<source port>.
<source port start>
is larger than <source port
| host {
<destination
<destination ipv4 start>
any
.
host
wildcard>, <destination
host own-address
wildcard>,
ipv4>.
commands for a VLAN
commands for an Ethernet
parameter specified is
end>.
is larger than
| own-address} | any |
<destination ipv6 start>
any
.
,
end>.