Hitachi GX1000-SMC013X Instruction Manual page 149

<icmp message>
Specifies the ICMP message name.
This parameter option is available only when the protocol is ICMP.
For details about the ICMP message names that can be specified, see Message
names that can be specified for ICMP (IPv4) and Message names that can be
specified for ICMP (IPv6).
1. Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2. Range of values:
None
<igmp type>
Specifies the IGMP type.
This parameter option is available only when the protocol is IGMP.
1. Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2. Range of values:
Specify 0 to 255 in decimal.
fragments
Specifies the second and subsequent fragmented packets.
1. Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2. Range of values:
None
Action parameters
action
To set or change an action parameter, you must set the
at the beginning of the action parameter.
1. Default value when this parameter is omitted:
None. (This
2. Range of values:
None
policy interface vlan
Specifies the output destination for policy-based routing.
1. Default value when this parameter is omitted:
None (policy-based routing is not used)
2. Range of values:
<vlan id>
For details about the VLAN ID, see Specifiable values for parameters.
<next hop ipv4>
Specifies a next-hop IPv4 address.
Specify an address in the network that connects to the specified destination
interface. However, you cannot specify the direct broadcast address of the
action
parameter keyword cannot be omitted if an action is set.)
next-hop
<vlan id>
action
<next hop ipv4>
parameter keyword
149