Hitachi GX1000-SMC013X Instruction Manual page 118

advance access-list
Configures an access list to serve as an Advance filter.
You can use one access list ID and specify multiple filter conditions.
For details about the number of access lists and filter conditions that can be created per
device, see Number of access lists that can be created for each CSU type.
You can specify parameters for policy-based routing if
action. To use an access group command to apply the access list to an interface, specify
Inbound
You can specify parameters for policy-based switching if
action. To use an access group command to apply the access list to an interface, specify
Inbound
Input format
To set information:
advance access-list
To delete information:
no advance access-list
Input mode
(config)
Parameters
<access list name>
Specifies the identifier of the Advance filter that is to be set.
The Device enters
Names that have already been used for IPv4 address filters, IPv4 packet filters, and
MAC filters cannot be specified.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
118
(receiving side) on a VLAN interface.
(receiving side) on an Ethernet interface.
config-adv-acl
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify a name of no more than 31 characters.
For details, see Specifiable values for parameters.
<access list name>
<access list name>
mode.
permit
is specified for the filter
permit
is specified for the filter