Hitachi GX1000-SMC013X Instruction Manual page 155

policy-channel-group
Sets the channel group number, which is included in destination interface information for
policy-based switching.
Destination interface information is selected in ascending order of the application sequence
set in policy-based switching list information.
A maximum of eight destination interface information items, including channel group
numbers, NIF numbers, and port numbers, can be set for one policy-based switching list.
Input format
To set or change information:
[
<sequence>
To delete information:
no
Input mode
(config-pol-sw)
Parameters
<sequence>
Specifies the sequence in which the destination interface information items for
policy-based switching are applied.
1.
2.
<channel group number>
Specifies the channel group number for link aggregation for the destination interface.
1.
2.
Default behavior
None
Impact on communication
If you change the destination interface information in the selected policy-based switching
list information which has already been set in the access list, the target packets might be
temporality discarded.
] policy-channel-group
<sequence>
Default value when this parameter is omitted:
If no destination interface information has been set for policy-based switching,
the initial value is set to 10.
If destination interface information has been set, the initial value is the
maximum value for the application sequence that has been set plus 10.
Note, however, that if the maximum value for the application sequence is
greater than 4,294,967,284, the value cannot be omitted.
Range of values:
Specify 1 to 4,294,967,294 (in decimal).
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
For details about channel group numbers, see Specifiable values for
parameters.
<channel group number>
155