Hitachi GX1000-SMC013X Instruction Manual page 377

Table 25-1 List of configuration commands
Specified by configuration
Permit
is specified.
deny
is specified.
accelerate-bypass
Not specified.
If frames are forwarded by using Layer 2 forwarding or discarded according to the MAC
address table by the default operation, access list statistics, which specifies the
corresponding policy-based switching list information, is incremented.
(2) Notes on policy-based switching group
(a) Notes on specifying accelerate-bypass for default operation
When specifying the
equipped with an SP on all the destination routes in the corresponding policy-based
switching list information.
(3) Policy-based routing group
(a) Route selection for policy-based routing group
(i) Monitoring results and priority for forwarding availability
Forwarding availability of the routes registered on policy-based routing list information is
determined according to the following monitoring results:
A route with the highest priority is selected among the routes available for forwarding.
Monitoring of the service status of a destination NIF equipped with an SP
When the following configuration commands specify a forwarding destination route and
default operation, forwarding availability is determined according to the service status of a
destination NIF equipped with an SP.
Forwarding is determined as available only when VLAN of a destination interface is up and
an SP is running.
Note that if a NIF equipped with an SP is not installed on the destination, its VLAN is judged
Default operation
Normal forwarding
Discard
Normal forwarding
Discard
accelerate-bypass
Monitoring of the VLAN status of a destination interface
Polling monitoring by the tracking functionality
Monitoring of the service status of a destination NIF equipped with an SP
policy-interface
command
vlan
The VLAN ID ( parameter) and the next-hop address (
parameter) of a destination interface
The default command
accelerate-bypass
Operation description
Frames to be forwarded are forwarded by
using Layer 2 forwarding according to the
MAC address table.
Frames to be forwarded are discarded.
Frames to be forwarded are forwarded by
using Layer 2 forwarding according to the
MAC address table.
Frames to be forwarded are discarded.
command for default operation, install a NIF
next-hop
377