Teledyne SyriXus 65x Installation And Operation Manual page 94

SyriXus Series Pumps Installation and Operation Guide
Section 4 Gradient Pumping for Pressure, Flow, and Concentration Modes
EAR99 Technology Subject to Restrictions Contained on the Cover Page
4-8
PGa FILE# 1
1. INIT =
2. FINAL =
FGa
FILE# 1
1. INIT% =
2. FIN% =
6. To set the initial pressure or flow for this step, press INIT (1) to
activate this parameter. Use the number keys to enter the
desired value, then press ENTER to save it.
7. To set the final pressure or flow for this step, press FINAL (2) to
activate this parameter. User the number keys to enter the
desired value, then press ENTER to save it.
8. Set either the desired RATE (3) of change or DURATION (4) in
minutes. Once one value has been set and saved, the other will
automatically appear.
DURATION in minutes can have a resolution of 0.1, with a maxi-
mum of 9,999 minutes per step.
9. If you want to add another step to the file program, press
INSERT (C).
10. The step number will increase by one, and the default initial
value will be the final value entered for the previous step. Edit as
desired.
11. When programming is complete, press the STORE key to save
the file and return to the home screen.
12. To start the program, press RUN two times.
When a gradient run is started, digital output '8' of the controller
ACCESSORY connector will toggle from high to low (open to
closed) for one second.
An entire gradient program can be removed only by deleting each of
its steps one at a time, as discussed in 4.5 "Review, Revise, & Hold
Options". When the last remaining step is deleted, the entire file is
removed.
STEP# 1 STORE TO EXIT
0PSI 3. RATE = 0:00PSI/MIN
0PSI 4. DURATION = 1.0MIN
INSERT DELETE
or
STEP# 1 STORE TO EXIT
3. RATE = 0.00%/MIN
4. DURATION = 1.0MIN
INSERT DELETE
NOTE
NOTE
NOTE