Table of Contents
Advertisement
SyriXus Series Pumps Installation and Operation Guide
Section 3 Basic Programming and Operation
3.5.2 Pump Status
3.5.3 External Control
3.5.4 Multiple Pumps
3.5.5 Total Volume Reset
Figure 3-5 Total volume reset
3.5.6 Valve
EAR99 Technology Subject to Restrictions Contained on the Cover Page
3-8
• Use softkey A, NEXT BAUD, to scroll through the available baud
rates. These are: 300, 1200, 2400, 4800, 9600, 19.2K, 38.4K,
57.6K, and 115.2K.
• Use softkey B, NEXT ID#, to scroll through the available ID
numbers. These are 1-7. Six is the default, as this is the unit
identifier used by the Teledyne ISCO LabVIEW™ software.
For information on serial control, refer to Section 8 "Serial Interface".
This option displays the controller software revision, and model of con-
nected pump(s).
• The first line displays the revision of the software.
• Lines 2, 3, and 4 display the type of pump connected to the A, B,
C, and D pump connectors, respectively.
This screen is also momentarily displayed automatically each time the
pump controller is switched ON.
The pump pressure or flow rate operation can be controlled externally
with an analog voltage. Complete instructions for this feature are pro-
vided in Section 3.12 "External Control - Analog".
One controller can control up to four pumps at once, either together or
independent of each other.
Complete information about using the
in Section 3.9 "Control of Multiple Pumps" and Section 5.5 "Con-
tinuous Flow Mode".
This option resets the total volume display of multi-pump pair AB or
multi-pump pair CD to zero when operating in Continuous Flow or
Modifier Addition Mode.
The total volume feature displays the sum of all the volumes delivered
by a pump pair in Continuous Flow Mode since the last reset. Refer to
Section 5.5.1 "Defining Operation".
1. AB PUMPS
2. CD PUMPS
3. AB AND CD PUMPS
This feature identifies the type of valves (1. ACTIVE [air], 2. PASSIVE
or 3. ELECTRIC 2 WAY) being used for the flow operation. Valves are
set to 'active' by default. If 1. ACTIVE or 3. ELECTRIC 2 WAY is
selected, the controller will match the pressure more closely between
the pumps, before switching delivery pumps.
If ball valves (500xv only) are being used and no check valve is in the
supply reservoir tubing, the No Check Valve option (refer to Section
5.5.4 "No Check Valve") should be used to create a timed delay after
valve open/closure, before switching delivery pumps. This delay is to
accommodate the slower opening/closing ball valves.
feature is provided
MULTI PUMP
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
