Pump Controller Rear Panel Connectors - Teledyne SyriXus 65x Installation And Operation Manual

SyriXus Series Pumps Installation and Operation Guide
Section 1 Introduction
Table 1-8 Pump Controller Rear Panel Connectors (Continued)
Figure 1-5 # Connector
6 RS-232/RS-485
7 USB/ETHERNET
8 4-20mA OUTPUT
ANALOG OUTPUT
ELECTRIC VALVES
12-CH OUTPUT
9 DIGITAL I/O
ANALOG OUTPUT
10 SERIAL TAG
11 CHASSIS GROUND
a. Connectors based on installed optional circuit board configuration.
EAR99 Technology Subject to Restrictions Contained on the Cover Page
1-12
This serial port connector may be used with an RS-232 or RS-485
cable to place the pump under remote control. Refer to Section 8
"Serial Interface" for RS-232 and Section 7 "Modbus Configuration"
for RS-485 pin connections.
a
Optional circuit provides USB and Ethernet functionality. Refer to Sec-
tion 8 "Serial Interface" for USB pin connections and Section 7
"Modbus Configuration" for Ethernet pin connections
a
Optional circuit provides 4-20mA current loop output and additional
digital inputs and outputs.
a
Optional circuit provides flow rate and volume outputs. Refer to 3.14
"Analog Flow Rate and Volume Output Options".
a
Optional circuit provides motor drive for valve operation.
a
Additional circuit provides flow rate, pressure, and volume outputs.
a
Optional circuit provides additional digital inputs and outputs.
a
Optional circuit provides flow rate and volume outputs. Refer to 3.14
"Analog Flow Rate and Volume Output Options".
This tag indicates the serial number of the instrument.
Ground point for high static or remote controller installations.
Description